GunVault MVB 1000 - Manual (Page 5)

- 4 -
ENROLLMENT OF THE ADMINISTRATOR
FINGERPRINTS
NOTE: The unit can store 120 fingerprints with the first two enrolled fingerprints
assigned as administrators. If the Learn Button is pressed and the LED flashes
red once and the unit beeps once the unit has reached its120 fingerprints
maximum.
NOTE: The
unit requires the first or the second administrator’s fingerprint to be
enrolled before adding additional fingerprints.
Register the first two fingerprints as the administrator.
Press the Learn Button. You will hear one beep and the LED will flash
green indicating the enrollment procedure has started.
Place your finger over the scanner with the tip of your finger at the top of
the finger guide as shown in Figure B.
Make sure you have good, flat contact with the scanner. Begin to swipe
your finger from Position 1 to Position 2 (Figure C), taking 1 to 2 seconds
to complete the swipe. Try to get your entire fingerprint to cross the
scanner.
Once the swipe is completed you will hear a beep. Repeat Step 3 one
more time. After swiping your finger two times the unit will beep twice, this
indicates a successful enrollment. If the swipe fails, the LED will flash red
and the unit will wait for another swipe.
Repeat steps 1 through 5 to add the second administrator.