IDX CW-5HD - Manual (Page 13)

- 13 -
4. Selecting frequencies and power output
The CW-5HD TX is equipped with a FREQ SELECT switch and POWER MODE
switch. With the FREQ SELECT switch, the transmitted frequency is set. The
frequency selection is needed only on the TX. The frequency of the RX does
not have to be selected because RX searches for the transmitted frequency
automatically. POWER MODE switch changes the transmitted output to HIGH
or LOW.
4.1. Service frequencies and transmitted output by regions
The service frequencies and the maximum transmitted outputs of CW-5HD
vary according to the designated regions.
The table below shows the service frequencies, corresponding channel
positions and the transmitted outputs by specific regions.
Region Channels
Service
frequencies
(MHz)
Transmitted
power
(HIGH Mode)
Transmitted
power
(LOW Mode)
United States
CH1 5745MHz
50mW
5mW
CH2 5825MHz
CH3 5180MHz
14.5mW
CH4 5220MHz
4.2. Automatic frequency selection
With FREQ SELECT in AUTO position, CW-5HD automatically selects the
channel according to the frequencies from 5180, 5200, 5220, 5745, 5765,
5785, 5805, 5825MHz.