4bank dmx control panel – Kino Flo 4Bank DMX (BAL-457) User Manual
Page 9
9
A)
Circular Output Connector: Provides electrical power to the lamp head
with the use of a 4Bank extension cable.
B)
DMX-In & DMX-Out: DMX-In receives DMX signals from Dimmer Board.
DMX-Out relays DMX signals through other Fixtures or Instruments.
Note: Each BAL-457 ballast has an “AUTO TERMINATE”
feature. The last ballast that does not have an XLR cable attached
to the DMX “Out” port will automatically terminate.
C)
DMX Address: Sets DMX Address of Fixture.
(Channels 1~4 = Lamps; Channel 5 = 4ft/2ft)
D)
DMX OK: Lights if valid DMX signal is present and conforms to
DMX512/1990 protocol.
E)
Manual Switches: Turns lamps on and off manually.
F)
Lamp Select Switch: Set to 4ft for 4ft lamps and 2ft for 2ft lamps.
G)
Fuse: Provides circuit protection. Note: If Fuse is “blown” or “open”,
replace with same type of fuse rating as marked.
4Bank DMX Control Panel
A
B
C
D
E
F
G