Replay XD XD1080 - Manual (Page 6)

1. Find the best mounting location for your Replay XD1080 and check your angles.
Rigid surfaces are ideal for the best video quality. Note: You can use the HDMI out for easy
framing or make a test recording and check it on an iPad/Mac/PC.
2. Snap Replay XD1080 into u-shape camera holder and rotate 360º to desired rotation.
3. Attach VHB SnapTray adhesive mount to a clean smooth surface.
-Flat SnapTray’s are good for flat smooth surfaces.
-Curved SnapTray’s are good for curved surfaces such as Helmets & Radius surfaces.
The 3M VHB adhesive is not recommended for textured surfaces.
4. Slide HeimLock mount into SnapTray until it is fully seated and clicks.
5. Adjust swivel 360º or tilt ~8º by releasing the heim cam lever and position Replay XD1080
in desired direction, then lock the cam lever. Make sure the cam lever is tight. There is an
adjustable tension wheel (*) to make sure you always have a positive tight lock.
H EI M LO CK M O U N T See our full range of mounts at www.Replayxd.com
*
VHB SnapTray HeimLock Mount
Unlock
Lock
Tilt Swivel
IMPORTANT
Use rubbing alcohol to clean
the mounting surface. Wipe
dry the surface. Apply your
VHB mount to surface. Press
and hold for sixty seconds to
allow adhesive to bond to
the surface. Bond strength
will increase through time.
At room temperature,
wait for at least 24 hours
to achieve 90% bonding
strength, and 72 hours for
100% bonding strength.