Revel Salon - Manual (Page 13)

Figure 9. How to connect the
REVEL ULTIMA STUDIO in
a single-wired system.
SINGLE-WIRED SYSTEM CONNECTIONS
For single-wired applications, simply leave the shorting straps in
place and connect the + and - from a single amplifier channel to the
+ and – terminals on the rear of the REVEL ULTIMA STUDIO,
as shown in Figure 9.
REVEL ULTIMA STUDIO
Owner’s Manual
13
Remove straps
for bi-wire
or bi-amp
Low Frequency Input High Frequency Input
+1 -1 0 +.5 -.5
Serial Number xxxx
Front Tweeter Level Rear Tweeter Level
Revel Corporation
Northridge, California
Made in U.S.A.
-3 0 Off
Remove straps
for bi-wire
or bi-amp
Low Frequency Input High Frequency Input
+1 -1
0 +.5 -.5
Front Tweeter Level Rear Tweeter Level
Revel Corporation
Northridge, California
Made in U.S.A.
-3 0
Off
Shorting Strap
(leave both in place)
red wht
REVEL
ULTIMA
STUDIO
Rear
Connector
Panel
Amplifier
(rear)
(one channel shown)
(one channel shown)