Starlight Xpress SXVR-H674 - Manual (Page 17)

Handbook for the SXVR-H674 Issue 1 March 2012
17
After the application of an ‘Unsharp mask’
In general terms, the larger the image and the worse the seeing, then the wider the
radius for best results. My Jupiter shots are usually about one third the height of the
CCD frame and I find that the ‘radius 5, power 5’ values are good for most average
seeing conditions. If you have exceptionally good conditions, then a reduction to R=3,
P=3 will probably give a more natural look to the image, as too large a radius and
power tends to outline edges with dark or bright borders.
As a finishing touch, the application of a Median filter or a Weighted Mean Low Pass
filter can be useful to smooth out the high frequency noise after a strong Unsharp
Mask.
As with deep-sky images, it is advantageous to sum planetary images together to
improve the signal to noise ratio. In this case, the ‘averaging’ option should always be
used, or the result is likely to exceed the dynamic range of the software and saturate
the highlights. Aligning the images is always something of a problem, as there are
rarely any stars to use when imaging the planets, but Jupiter’s satellites can be useful
reference points. Otherwise, you will have to find a well-defined feature on the planet,
or estimate where the centre of the disk is located. Some more sophisticated software
can automatically align planetary images and you may find these programs (e.g.
‘Registax’) to be very useful.
*********************************************************************
Using the add-on autoguider:
A very useful accessory is the add-on autoguider head, which takes its power and
control signals directly from the SXVR camera, via the 18 way socket on its rear
panel. The autoguider is only 1.25” in diameter and has a video style ‘CS’ mount
thread in its nose, so video lenses may be attached. The guider may be used with