Tweco 51 with SL100SV CutMaster - Manual (Page 3)

WARNINGS
Read and understand this entire Manual and your employer’s safety practices before installing, operat-
ing, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
Automated Plasma Cutting System
Automated CutMaster™ 51 Power Supply
SL100SV Machine Torch
Operating Manual Number 0-4640
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
Copyright 2004, 2005, 2006, 2007 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the pub-
lisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any
loss or damage caused by any error or omission in this Manual, whether such error
results from negligence, accident, or any other cause.
Printed in the United States of America
Publication Date: April 2, 2007
Record the following information for Warranty purposes:
Where Purchased:_______________________________ _______________
Purchase Date:__________________________________ _______________
Power Supply Serial #:___________________________ _______________
Torch Serial #:___________________________________ ______________