Casio WK7500E1A - Manual (Page 16)

Selecting and Playing a Tone
E-14
■ To disable Auto Power Off
1.
While the Digital Keyboard is turned on, press
the L-1 (POWER) button to turn it off.
2.
While holding down the L-4 ([A] POPS/ROCK/
DANCE) button, press the L-1 (POWER) button
to turn on the Digital Keyboard.
• Auto Power Off will be disabled at this time.
• Turning off the keyboard after performing the above steps
will re-enable Auto Power Off.
1. While holding down the L-18 (ACCOMP ON/
OFF) button, press the L-17 (PLAY/STOP)
button.
• This starts demo tune play.
• The Digital Keyboard has a total of five demo tunes.
You also can use the R-14 (–, +) buttons to select a
demo tune.
• Pressing the L-15 (dFF) button performs fast forward
play of the demo tune, while the L-14 (sREW) button
performs fast backward play. Holding down the L-14
(sREW) button until playback reaches the beginning
of the current song will stop playback there. Normal
playback will resume when you release the L-14
(sREW) button. Holding down the L-15 (dFF)
button continues fast forward playback, even after the
end of a song is reached.
• You can play along on the keyboard with demo tune
play. Note, however, that you cannot change the tone
assigned to the keyboard. Only the key operations
described above are supported during demo tune
playback.
2. To stop demo tune playback, press the L-17
(PLAY/STOP) button.
The tones of this Digital Keyboard are divided among groups,
each of which corresponds to one of the 12 TONE buttons.
You can specify a tone by its group and its tone number.
Use the following procedure to select a single tone that is
applied across the entire keyboard.
1. Refer to the separate “Appendix” to look up the
group and the number of the tone you want to
select.
2.
Check to make sure that the @ and A
indicators are not on the display.
• If they are displayed, press the R-19 (SPLIT) button
and/or R-20 (LAYER) button to clear both indicators
from the display.
3. Use buttons R-1 ([A] PIANO) through R-11 ([K]
USER TONES) to select a tone group.
• The R-11 ([K] USER TONES) button selects the user
tone group. For details, see “Using the Tone Editor”
(page E-44).
• The R-12 ([L] DRAWBAR ORGAN) button selects the
drawbar organ tone group. See “Using Drawbar Organ
Tones” (page E-50) for more information.
4. Use the dial to scroll through the tone numbers
until the one you want is displayed.
Example: Group [C], Number 004
Listening to Demo Tunes
Selecting a Tone
To select a tone
Tone name Group
Number
CTK7000_e.book 14 ページ ２０１０年７月２１日 水曜日 午後５時１５分