Humboldt H-3625 Flow Table with Mold - Manual (Page 3)

Introduction
These Flow Tables are constructed in accordance with the current ASTM Specification
C 230, using the inch-pound units for the tables, and for accessory sets of molds and
calipers, both inch-pound and metric (SI) units.
Models
Shipping Wt.
H-3624 Flow Table, Motorized, with automatic counter (110V, 60Hz) 108 lbs. (49kg)
H-3624.5F, same H-3624 except (220VAC, 50 Hz, 1 ph) 118 lbs. (53.5kg)
H-3625 Flow Table, Motorized (110V, 60Hz) 100 lbs.(45kg)
H-3625.5F, same as H-3625 except (220 VAC, 50 Hz, 1 ph) 110 lbs. (49.9kg)
H-3620 Flow Table, Hand driven 30 lbs. (13.6kg)
Components and Accessories (ordered separately):
H-3622 Mold (English)
H-3622M Mold (Metric)
H-3621 Caliper (English)
H-3621M Caliper (Metric)
H-3623 Circular shield, for use with molds to protect table top from mortar spills.
H-4144 Straight edge, for cutting off mortar flush with surface of mold.
H-3614 Automatic counter kit
General Information
Inspection:
Your Flow Table was thoroughly inspected before it was shipped and should be ready to
operate after it is properly mounted (see below). Notify Humboldt Mfg. Co. or your local
agent and file claim with any carriers involved if you find any damage to the machine.
Physical Specification:
Shipping weight (see above)
Overall height, table & frame:
9 ¾" (25 cm) approx.
Diameter of table top: 10" (25.4 cm)
Base plate: 10" x 10" x 1" (25.4 x 25.4 x 2.54 cm)
Power Supply:
110 VAC 60 Hz 1 phase (H-3624&H-3625), 200 watts
220 VAC 50 Hz 1 phase (H-3624.5F&H-3625.5F), 200 watts
Initial Installation
Remove the packing list and verify that all parts have been received. Normally you will
receive the product complete in one carton.
It is necessary to mount the base plate to which the flow table is mounted to the top
of a concrete pedestal using ½" (13mm) bolts imbedded at least 6" (150mm) into the
pedestal. The pedestal is to be cast inverted on the base plate such that positive contact
is maintained at all points between the base plate and pedestal (dimensions are as
described in ASTM C230).
The motor mounting and supporting plate is attached to the side of the pedestal
as shown with 5/16" (8.5mm) imbedded studs or anchored bolts. Use the attached
template to mark the hole pattern.