Bissell 42H5 - Manual (Page 10)

w w w . b i s s e l l . c o m
M
aintenance and care
10
4. Remove the inner cyclone by grasping the
bottom of the cyclone and turning clockwise
to unlock. Pull straight down to remove. Clean
with a cloth to remove dust and debris
5. Remove the screen by pulling straight
down. Clean with a cloth or a soft brush to
remove dust and debris.
6. The tank may also be wiped clean with a
damp cloth. Make sure the tank is
completely dry before reassembling.
7. To reassemble, hold the carry handle and
place the screen back onto the top portion
of the dirt container. Be sure to align the
notch on the top with the insert on the flat
edge of the screen. Then place the inner
cyclone back into the screen by aligning
the notches at the top of the inner cyclone
with the inserts inside the screen and turning
counter clockwise to lock into place.
8. Place the top portion back onto the dirt
container by grasping the carry handle
and turning clockwise to lock into place.
Be sure that the dirt container release
button is aligned with the emptying button
when locked into place.
Cleaning the pre-motor filter
The pre-motor filter protects the motor
from dirt and dust particles. Use only
BISSELL replacement filters in your
Pet Hair Eraser.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. Remove the dirt container from the vacuum.
3. The pre-motor filter is located behind the
door labeled “FILTER” on the main body
of the vacuum. Open the door by pushing
up on the tab at the bottom of the door
and pulling out to remove.
4. Remove the filter tray by pulling up on the
tab of the tray. Remove the pre-motor filter
and set aside. Tap the tray gently over a
trash can to remove any dirt or debris.
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust from
products like plaster, concrete or ashes
will damage the motor and void the
warranty.
Filter Tray
Pre-Motor Filter
3.
4.
Cleaning the inner cyclone & screen continued
4.
5.