BMW M6 Coupe 2006 - Manual (Page 188)

Replacing components
186
Model with pressure gauge on hose*
3 Connector and cable for lighter socket
4 Mounting for sealing bottle
5 Compressor
6 On/Off switch
7 Pressure gauge for indicating tire inflation
pressure
8 Screw on pressure gauge for reducing tire
inflation pressure
9 Connecting hose for connecting compres-
sor and sealant bottle or compressor and
wheel
Connector, cable and connecting hose are
stored in the compressor housing.
Model with pressure gauge integrated
in housing*
3 Connector and cable for lighter socket
4 Mounting for sealing bottle
5 Compressor
6 On/Off switch
7 Pressure gauge for indicating tire inflation
pressure
8 Button for reducing tire inflation pressure
9 Connecting hose for connecting compres-
sor and sealant bottle or compressor and
wheel
Connector, cable and connecting hose are
stored on underside of compressor.
Using M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
> Fill sealant into wheel, refer to page 186 .
> Distribute sealant, refer to page 187 .
> Produce tire inflation pressure, refer to
page
187 .
Filling sealant into wheel
Strictly comply with the specified order,
otherwise highly pressurized sealant
could escape. <
1. Shake sealant bottle.
2. Screw hose 9 onto connection of sealant
bottle.
3. For model with pressure gauge on hose:
Make sure that screw
8 on pressure gauge
is closed.
4. Screw dust cap off valve of defective wheel
and screw filling hose
2 of sealant bottle
onto valve.
5. Insert sealant bottle on compressor hous-
ing so that it is positioned upright.
6. Make sure that device is switched off,
position 0.
7. Insert connector 3 into lighter socket in
vehicle interior, refer to page 93 .
Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG