FRIGIDAIRE FGET3065KW - Manual (Page 28)

28
CARE & CLEANING
TO REMOVE THE “HIDDEN BAKE” COVER
(some models)
1. In order to remove the “hidden bake” cover, pull the
back edge with one hand about ½ inch and lift up the
“hidden bake” cover with both hands. (See picture)
2. When re-installing the “hidden bake” cover, be sure
to put it all the way to the back of the oven and lay it
down on the 2 shoulder screws. Then push the front
edge of the cover in its place below the front bracket.
To have easier access to the “hidden bake” cover, you can
remove the oven door by following the instructions on
previous page.
IMPORTANT
Always replace the “hidden bake” cover before the next
use.
CAUTION
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
CAUTION
BE SURE OVEN IS COOL
CHANGING OVEN LIGHT
On some models an interior oven light will turn on
automatically when the oven is opened. The oven light
may be turned on when the door is closed by using the
oven light switch located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held
in place by a wire holder. THIS GLASS SHIELD MUST
ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against
possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side
to release glass shield, change bulb and be sure to
replace glass shield.