Cisco 2940 - Manual (Page 70)

C-2
Catalyst 2940 Switch Hardware Installation Guide
OL-6157-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Taking Out What You Need
After you have entered the configuration information for the switch, save it to flash memory by using
the write memory privileged EXEC command.
Note While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the
write memory
command. You lose the Telnet connection after entering the write memory command.
For more information about using the CLI, see the command reference for this release.
Accessing the CLI Through the Console Port
You can access the CLI by connecting the console port of the switch to the serial port on your PC or
workstation and access the switch through a Telnet session. To access the switch through the console
port, follow the steps in the rest of this chapter, beginning with the
“Taking Out What You Need” section
on page C-2 .
Taking Out What You Need
Remove the items from the shipping container, as shown in Figure C-1 .
Figure C-1 Catalyst 2940 Switch, Console Cable, and AC Power Cord
1 Switch 3 AC power cord
2 Console cable
1
2
3
89890
1x 2x 3x 4x 5x 6x 7x 8x Catalyst 2940
SERIES 1
SYST
STAT
DPLX
SPD
MODE