Dell 3330dn Mono Laser Printer - Manual (Page 20)

3 Right side 200 mm (8.0 in.)
4 Left side 12.7 mm (0.5 in.)
5 Top 300 mm (12.0 in.)
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
You can customize your printer connectivity and memory capacity by adding optional cards. The instructions in this
section explain how to install the available cards; you can also use them to locate a card for removal.
Available internal options
Memory cards
• Printer memory
• Flash memory
• Fonts
Firmware cards
• Bar Code
• Forms Card
• PrintCryption TM
Accessing the system board to install internal options
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
1 As you face the printer, the system board door is on the right side. Open the system board door.
Additional printer setup
20