Dell XPS M1710 (MXG061, Early 2006) User Manual
Page 49
Display: Dell XPS M1710 Service Manual
file:///C|/Users/santhosh_v.ASIA-PACIFIC/Desktop/Hawke/New%20folder/display.htm[2/21/2014 11:23:47 AM]
1 display panel
2 M2 x 3-mm screws (8)
3 display back cover
4 grounding wire and captive screw
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product
Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an
unpainted metal surface (such as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
) before working inside the computer.
1. Follow the instructions in
Before Working Inside Your Computer
.
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Loosen the captive ground screw that attaches the display-panel ground wire to the display back cover.
5. Remove the eight M2 x 3-mm screws (four on each side of the display panel).
6. Lift the display panel out of the display back cover.
7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display
connector.
8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.