Dell PowerEdge T605 - Manual (Page 189)

Troubleshooting Your System
189
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 68.
4 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
5 Remove the processor shroud. See "Removing the Processor Shroud" on
page 72.
6 Ensure that each processor and heat sink is properly installed. See
"Installing a Processor" on page 137.
7 Install the processor shroud. See "Installing the Processor Shroud" on
page 74.
8 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
9 Close the system. See "Closing the System" on page 70.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
11 If possible, run the appropriate online diagnostic test. See "Running the
System Diagnostics" on page 193.
If the tests fail or the problem persists, continue to the next step.
12 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
13 Open the system. See "Opening the System" on page 68.
14 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
15 Remove the processor shroud. See "Removing the Processor Shroud" on
page 72.
16 Remove processor 2. See "Removing a Processor" on page 134.
To locate processor 2, see Figure 6-1.
If only one processor is installed, replace the processor. See "Getting Help"
on page 205.
17 Install the processor shroud. See "Installing the Processor Shroud" on
page 74.