Dell INSPIRON 2600 - Manual (Page 7)

Recommended Tools
The procedures in this document require the following tools:
l #1 magnetized Phillips screwdriver
l ¼ -inch flat-blade screwdriver
l Nut driver
l Small plastic scribe
l Microprocessor extractor
l Flash BIOS update program floppy disk or CD
Computer Orientation
Screw Identification
When you are removing and replacing components, photocopy " Screw Identification " as a tool to lay out and keep track of the screws. The placemat provides
the number of screws and their sizes.
1 back
2 right
3 front
4 left
NOTICE: When reinstalling a screw, you must use a screw of the correct diameter and length. Ensure that the screw is properly aligned with its
corresponding hole, and avoid over tightening.
Hard Drive Door:
(1 each)
Memory Module/
Modem Cover:
(1 each)