SONiVOX Vocalizer Pro - Manual (Page 20)

20
EQ
The EQ section contains various equalization controls
in three rows, with each column corresponding to a
processor on the Modulation Tab (A1, A2, B1, and
B2, respectively).
•
Gain: Boost or reduce the amount of gain of the
center frequency set by the Freq knob.
• Q: Use this knob to increase or reduce the
bandwidth around the center frequency set by
the Freq knob. Higher Q settings create a wider
bandwidth, so more frequencies around the
center frequency will be affected by the EQ.
Lower Q settings create a narrower bandwidth
around the center frequency.
• Freq: Use this knob to set the center frequency to boost or reduce with the Gain knob.
Chorus
The Chorus section lets you apply chorus to the sound, creating a shimmery,
wavy, or watery effect, depending on your settings.
•
Dry: Adjust the level of the "dry" signal (without chorus applied) with this
knob.
• Wet: Adjust the level of the "wet" signal (only the signal with chorus
applied) with this knob.
• LFO Depth: Adjust the depth or intensity of the chorus effect with this
knob.
• LFO Rate: Adjust the rate of chorus with this knob.
• Delay: Adjust the amount of delay of this effect with this knob.
• Feedback: Adjust how much of the effect signal is routed back into the effect again.