To check the setting, To cancel the timer operation, Precautions – Sony MHC-RXD6AV User Manual

Page 36: On operating voltage, On safety, On placement, On operation, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Timer-recording radio programs
(continued)

To check the setting

Press TIMER SELECT and turn the jog dial to
select "REC", then press ENTER/NEXT.

To change the setting, start over from step 1.

To cancel the timer operation

Press TIMER SELECT and turn the jog dial to
select "TIMER OFF", then press ENTER/
NEXT.

Notes

• If the system is on at the preset time, the recording

will not be made.

• You cannot set the timer if the timer on and off

times are the same.

• When you set the Sleep Timer, the Timer-

recording will not turn on the system until the
Sleep Timer turns it off.

• You cannot activate the Timer-recording and

Daily Timer at the same time.

Additional Information

Precautions

On operating voltage

Before operating the system, check that the
operating voltage of your system is identical with
the voltage of your local power supply.

On safety

• The system is not disconnected from the AC

power source (mains) as long as it is connected to
the wall outlet, even if the system itself has been
turned off.

• Unplug the system from the wall outlet (mains) if

it is not to be used for an extended period of time.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.

■ • Should any solid object or liquid fall into the

component, unplug the system and have the
component checked by qualified personnel before
operating it any further.

• The AC power cord must be changed only at the

qualified service shop.

On placement

• Place the system in a location with adequate

ventilation to prevent heat build-up in d>e system.

• Do not place the system in an inclined position.
• Do not place the system in locations where it is;

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Vibrating
— Subject to direct sunlight

On operation

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.

• When you move the system, take out any discs.

If you have any questions or problems concerning
your system, please consult your nearest Sony
dealer. '

I

36

Advertising