Sony STR-D1011 - Manual (Page 17)

Receiving Broadcasts
Tuning in a Station Directly (Direct Tuning)
Enter the frequency with the numeric buttons.
The entered frequency is displayed.
Example 1: FM 102.50 MHz
1 0 2 5 0
Example 2: AM 1350 kHz
1 3 5
I I I I I I I
FM 1 U L . J U
AM
1 1 1 1 1
kH z
1 J J U
To correct the entered frequency
Repeat steps 3 to 4.
For entering AM frequencies
You need not enter the last "0"
However, if you have changed the AM tuning interval to 9
kHz, enter all the digits.
If you enter a frequency not covered by the tuning
interval
The entered value is automaticaliy rounded up or down to
the closest value covered by the tuning interval.
Tuning intervals for direct tuning are the followings:
FM: 50 kHz interval
AM: 10 kHz interval (changeable to the 9 kHz interval)
(See page 5)
When the entered frequency does not exist in the
receivable frequency range
The entered digits (up to 5 digits for FM or up to 3 digits tor
AM) blink in the frequency display area, and reception does
not take place.
If this occurs, press DIRECT TUNING again, and enter the
correct frequency (the frequency range of the receiver is
87.50 to 108.0 MHz for FM, and 530 to 1710 kHz for AM).
When an FM stereo program is noisy
When the unit receives an FM stereo program, the STEREO
ihdicator lights on the display. If the stereo program is noisy,
press FM MODE to change the mode over the MONO. This
eliminates the stereo effect, but the noise will be greatly
reduced.
To return to the stereo mode, press FM MODE again.
17