Sony CDX-71RF - Manual (Page 9)

CD Changer Operation
Listening to the CD
Playback
Turn on the FM tuner of your car audio
and select the frequency from 88.3 MHz,
88.7 MHz. 89.7 MHz or 89.9 MHz
whichever has been selected by the
procedure described in "Changing the
Transmitting Frequency" (page 6).
See the operation manual of your car
audio about the FM tuning as well.
Press either the POWER switch on the
display unit or the CD button* on the
remote commander. The CD playback
will start.
* If the POWER SELECT switch on the hideaway unit
is set to the OFF position and the display on the
display unit is turned off, you will not be able to
start CD playback with the remote commander. In
this case, press the POWER switch on the display
unit.
3 Adjust the volume with the volume
control on the car audio.
If the system is in the normal playing mode, after the end of
a disc, the disc with the next number shown on the display
played. If two or more CD changers are connected, after the
end of the last disc in the first changer, the first disc in the
CD changer with the next number shown will be played.
The order of disc play can be rearranged by changing the
playing modes (page 8).
Stopping CD Playback
Press either the POWER switch on the
display unit or the OFF button on the
remote commander.
To resume CD playback, press the
POWER switch on the display unit or
the CD button on the remote
commander.
Notes
• When CD playback is stopped, you may hear some noise
from the speakers. To prevent this from Imppening, turn
the volume down before stopping CD playback.
• If you turn off the ignition of your car without stopping
CD playback, it will automatically resume CD playback
from where it ums stopped the next time you turn on the
ignition.
I
Listening to the Radio
Press the POWER switch on the display
unit or the OFF button on the remote
commander to stop CD playback before
tuning in a radio station.
Be sure to stop CD playback before you start
listening to the radio.
Otherwise there may be some mterference in
the radio reception.
To restart CD playback, set the frequency of
the FM tuner to the frequency previously
selected in "Changing the Transmitting
Frequency" (page 6) and press the POWER
switch on the display unit, the CD button on
the remote commander.
Note
When this system is used with your car audio, the
reception of the tuner may become slightly worse than
usual.
Tape Playback
n
o
n
Press the POWER switch on the display
unit or the OFF button on the remote
commander to stop CD playback before
starting tape playback.
O)
iQ
(D
O
T3
fO
O)
To restart CD playback, turn on the FM tuner
and set the FM frequency to the one previously
selected in "Changing the Transmitting
Frequency" (page 6) and press the POWER
switch on the display unit, the CD button on
the remote commander.
o