Di sc-20, The programs remain even after program play ends, The programs remain until you erase them – Sony CDP-CX270 User Manual
Page 19: Creating a program using the remote [t, Disc-2d* 20 all, Disc-20* □ isc-[ .-j
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Playing CDs
1
Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the front
panel display.
If a program is already stored in the selected
program number, the last step of the program
appears in the front panel display. When you want
to erase the whole program, hold down CLEAR
until "ALL CLEAR" appears in the front panel
display (see page 20).
2
Turn the JOG dial until the disc number you want
appears in the front panel display.
20
*DISC-2D*
20 ALL
3
To program a whole disc, skip this step. Press
KK1/I>C>1I until the track number you want
appears in the front panel display.
lOGRMII
2 Q
*DI SC-20*
20 ,3, -
a
}
Track number
4
Press ENTER or PRCXiRAM.
The track being programmed
The disc being
PlayingLorder
programmed
5
To program other discs/tracks, do the following:
To program
Repeat Steps
Other discs
2 and 4
Other tracks on the same disc
3 and 4
Other tracks on other discs
2 through 4
6
Press to start Program
Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
When you press the O button, you can play the same
program again.
'Q' When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The programs remain until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
When connected to the second player, you can
program tracks/discs of both players in the same
program
when selecting a disc, press PLAYER SELECT repeatedly
until "2nd PLAYER" appears in the front panel display.
Then select the disc you want to program.
Creating a program using the remote
[T]
Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the front
panel display.
2
Press DISC/CAPS.
20
*DISC-20*
□ ISC-[ .-J
(Continued)
1 9