Craftsman 580.752400 - Manual (Page 6)

ASSEMBLY
Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners opposite guide handle end of
carton from top to bottom so the panel can be
folded down flat.
• Remove fillers, accesories and parts bag shipped
with your pressure washer.
• Roll the pressure washer out the open end of the
carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check ail contents. If any parts are missing or damaged,
call the pressure washer helpline at 1^00-222-3136.
The main unit
Handle
Spray gun
High pressure hose
Nozzle extension with Hi/Lo adjustable nozzle
Engine oil
Parts bag (which includes items listed below)
Owner’s manual
Registration card
Handle attachment hardware
Become familiar with each piece before assembling
the pressure washer. Check ail contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Attach handle.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect pressure hose to spray gun and pump.
5. Connect water supply to pump.
Attach Handle
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Align Holes*
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand. V,
a.
3. Insert one “L” hooks through hole just under
billboard on left side of handle (viewing from rear
of unit). Hold hook in place and attach plastic knob
from inside of unit. Tighten by hand.
k
Spray Gun
Hook
Hose Hook
4. Insert other “L” hook through hole just above
billboard on right side of handle (viewing from rear
of unit). Hold hook in place and attach plastic knob
from inside of unit. Tighten by hand.