Abrasive belt adjusting screws, Work table tilt lock screw locks, Work table tilt lock screw – Craftsman 113.225931 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BELT ADJUSTING
1
.
ABRASIVE BELT ADJUSTING SCREWS
cause the idler pulley to move irt or out for applying
tension to the abrasive iaelt or for tracking it. They
are adjusted using the 1/2" wrenches.
See "Assembly" section ,. . "Installing Abrasive Belt".
2.
ABRASIVE BELT LOCKING SCREWS
lock
the adjustment mechanism after the abrasive belt is
tensioned and tracking properly. They are locked
using the 1/2" wrench.
See "assembly" section . ,
Belt".
, "Installing Abrasive
SCREW
(ONE ON EACH SIDE!
3.
WORK TABLE TILT LOCK SCREW
locks
the table. It is locked using the 1/2" wrench.
a. Using a combination square, check the angle of
the table widi the disc.
NOTE; The combirration square must be '"true"—
See start of assembly section on Pg. 6 for checking
method.
b. If the table is not 90® with the disc . . . loosen
tilt lock screw and tilt table.
c. Loosen the lock nut using a 7/16" wrench,
d. Strew the stop screw in or out, using a 3/8"
vwrench so that when ithe table touches the stop
screw, the table is 90° to thé disc.
e. Tighten the lock nut.
17