Alumax 650S - Manual (Page 7)

Page 7 of 8 EPH-N00-06015
1-29-09
Attach one of the single mount finger pulls [Y] to
the outside of the interior panel with the finger pull on the
side of the panel nearest the shower head. Use a #10 x
¾” truss head screw
[Z] to make the attachment. Attach
the remaining single mount finger pull to the other side
of the interior panel with the finger pull on the interior.
Peel the backing from the back side of the Alumax decal
[S] and press it into the recess of the finger pulls.
Note: Do not over tighten the finger pull screws.
Attach a towel bar assembly (with the open slot
in the bar downward) to the exterior panel with a #10-24
x 7/8" truss head screw
[N] thru the inner rail. Insert a
#10-24 x 1 1/8" flat head screw [P] thru an acrylic finger
pull [R], thru the outer rail and into the outer towel bar
bracket. Peel the backing from a A
LUMAX
decal [S] press
it into the recess in the acrylic finger pull.
NOTE: Do not overtighten the towel bar screws.
Locate the nylon bottom guide [T] in the middle
of the tub track [A] with the door panels in the position
shown. With a 7/64" bit, drill a hole into the V-groove
through the mounting hole in the bottom guide. Install
the bottom guide with a #6 x 3/8" pan head screw
[U]
thru the drilled hole.
DECAL
SINGLE MOUNT
FINGER PULL
3/4” TRUSS
HEAD SCREW
DECAL
SINGLE MOUNT
FINGER PULL
10
11
12