Arc Machines 205 WDR - Manual (Page 44)

M O D E L 2 0 5
O P E R A T O R ’ S M A N U A L
40 40 40 40
4.11 4.11 4.11 4.11 WELD DATA RECORDING WELD DATA RECORDING WELD DATA RECORDING WELD DATA RECORDING
• Setup and Enable Weld Data Recording
1. Press WDR to open the Weld Data Recording screen.
2. Enter data in each of the fields
Note
Power Supply Model Number, Power Supply Serial Number and Weldhead Model Number
are already stored in the system so these fields are automatically filled.
Note
The ONLY required field is Weld ID and it must be unique. If a non-unique value is entered
(Weld
Camino de las Estrellas ID that has already been used) an error message will be
displayed.
3. Press WDR ENABLED to turn on Weld Data Recording.