Memory installation – Dataram DRST2000 User Manual
Page 2
MEMORY INSTALLATION
MEMORY INSTALLATION
Note: Refer to your system owner’s manual for detailed instructions.
Caution: System parts are sensitive to electrostatic discharge and can be
damaged by the static charge you may carry. You should wear a
grounded wrist strap.
1.
Power off the server and remove the main cover.
2.
Locate the DIMM slot(s) on the motherboard to which you want to install
or replace a memory module.
3.
If replacing a DIMM, push down on the ejector levers on each side of the
DIMM until the DIMM is released.
4.
Grasp the top corners of the faulty DIMM and remove it from the system.
5.
To install a DIMM, open both ejector levers on each slot.
6.
Position the DIMM over the slot so that the alignment notches on the
DIMM match the notches on the connector.
7.
Press firmly with your thumbs on both top ends of the module, applying
equal pressure until the module snaps into place. Lock the module in the
socket by pushing up on the ejector levers until they are in their upright
position.
8.
Continue to install the remaining memory modules until you have filled
the bank with two identical modules. Repeat the above steps for each
bank of memory you wish to install.
9.
Reconnect the power cords and external cables, replace the cover and
turn on the system.
Sun Fire T2000 DIMM Locations
10. After you reboot, ensure the system recognizes the new memory
configuration.
MEMORY INSTALLATION
MEMORY INSTALLATION
Note: Refer to your system owner’s manual for detailed instructions.
Caution: System parts are sensitive to electrostatic discharge and can be
damaged by the static charge you may carry. You should wear a
grounded wrist strap.
1.
Power off the server and remove the main cover.
2.
Locate the DIMM slot(s) on the motherboard to which you want to install
or replace a memory module.
3.
If replacing a DIMM, push down on the ejector levers on each side of the
DIMM until the DIMM is released.
4.
Grasp the top corners of the faulty DIMM and remove it from the system.
5.
To install a DIMM, open both ejector levers on each slot.
6.
Position the DIMM over the slot so that the alignment notches on the
DIMM match the notches on the connector.
7.
Press firmly with your thumbs on both top ends of the module, applying
equal pressure until the module snaps into place. Lock the module in the
socket by pushing up on the ejector levers until they are in their upright
position.
8.
Continue to install the remaining memory modules until you have filled
the bank with two identical modules. Repeat the above steps for each
bank of memory you wish to install.
9.
Reconnect the power cords and external cables, replace the cover and
turn on the system.
Sun Fire T2000 DIMM Locations
10. After you reboot, ensure the system recognizes the new memory
configuration.