Dynojet 250ix: Pit Installation Guide - Manual (Page 33)

I N S T A L L A T I O N
Eddy Current Brake Installation
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
2-11
3 Remove the eight bolts, washers, and six nuts from the dyno frame where the
connector plates will attach (where the connector plate attaches to the starter
brace, there are only two nuts).
4 Remove the starter brace and set aside.
5 Keeping the panels parallel, slide the eddy current brake towards the dyno. Slide
the driveline assembly over the key on the dyno shaft. You will need to support
the driveline assembly as you slide it onto the dyno shaft.
6 Continue sliding the eddy current brake towards the dyno until the uprights on
the brake and dyno are flush.
7 Loosely secure the connector plates to the dyno frame using the eight bolts,
washers, and six nuts removed earlier.
Note: Do not tighten the bolts.
8 Replace the existing set screws on the driveline assembly with the thread-lock set
screws provided.
9 Tighten the driveline assembly set screws.
Figure 2-6: Tighten the Set Screws
brake shaft dyno shaft
set screw