Dynojet 248x: DynoWare EX+ Upgrade - Manual (Page 12)

DynoWare EX+ Upgrade For The Model 248 Dynamometer
D Y N O W A R E E X + U P G R A D E
The DynoWare EX+ System
6
I NSTALLING THE N EW D YNO H ARDWARE
1 Mark the mounting holes for the Breakout board mounting bracket.
1a
Using the mounting bracket as a template, place the bracket so the holes are
centered on the cross brace and 2.25-inches in from the post.
1b Using a center punch, mark two mounting holes in the dyno frame.
1c Drill and tap the mounting holes for 1/4-inch UNC bolts.
2 Secure the Breakout board to the mounting bracket using four #8 screws.
3 Install the mounting bracket to the dyno frame using two 1/4-inch allen head
bolts.
Note: If you are installing a proportional air brake system, skip the following
instructions and continue with “Installing the Proportional Air Brake System” on
page A-3.
4 Screw the air brake control switch into the top of the air canister on the right
hand side of the dyno.
Figure 6: Install the New Dyno Hardware
use bracket to
mark mounting
holes
secure breakout board
to bracket
install bracket
air brake control
switch assembly
cross brace
post
air canister
mark mounting
holes
install air brake
control switch