Dynojet Data Link Module - OBDII User Manual
Page 25
D A T A L I N K M O D U L E - O B D I I B A S I C C O N F I G U R A T I O N
Introduction
Version 4
Data Link Module-OBDII Installation and User Guide
A-3
Category 5 Standard Cable—connects to your wired network with a category 5
standard cable. Refer to “Configuring the DJDLM-OBDII with a Category 5 Standard
Cable” on page A-8 for more information.
Figure A-4: Category 5 Standard Cable Configuration
C
ONNECTING
THE
DJDLM-OBDII
Once unpacked, a direct connection via a crossover cable must be made.
1
Plug the DJDLM-OBDII into a vehicle for a power source. Turn the vehicle’s key to
the ON position. The engine may need to be running on some vehicles in order to
power the DJDLM-OBDII.
2
Connect the crossover cable to the DJDLM-OBDII and to your PC.
3
Turn on the DJDLM-OBDII power.
4
Open Internet Explorer.
5
In the address bar, type 192.168.0.101. Do not type anything else.
6
Press Enter.
You will see the following window when successfully connected.
Figure A-5: DJDLM-OBDII Successfully Connected