Eden WTDI Pedal - Manual

WTDI
ʻWORLD TOURʻ DIRECT BOX PREAMP PEDAL OPERATION MANUAL
1. 1/4” instrument input - Plug your instrument into this.
2. Input Gain Level - Regulates the gain stage of the preamplifier and controls the
amount of signal available to the unit.
3. Bass EQ level - 15dB of boost or cut at approximately 30Hz.
4. Bass Boost - Dynamic Bass boost along Fletcher-Munson Curve
5. Midrange EQ - Boost or cut middle frequency (as selected by mid-shift)
6. Mid Shift - flip between 550Hz and 2.2KHz as adjustable midrange frequency
7. Treble -15db of boost or cut at approximately 5KHz
8. Enhance - ʻakaʼ the “Magic Knob” This complex control simultaneously boosts the
very low bass, upper middle, and high frequencies.
9. Compressor - Smooths out peaks in signal while boosting low level information.
Amount of compression controlled by knob and fed by input gain level.
10. Master Level Output - Adjusts overall output and loudness to (11) & (13)
11. XLR Direct output - Connect to Balanced PA or recording input.
12. Ground Lift for XLR output - lifts ground to match with other gear.
13. 1/4” Instrument level output - Connects to amplifier input, power amp input or
unbalanced audio input of any device.
14. Power Supply connection - Plug in included 12-18Volt PSU - Center Pin Positive
15. Bypass footswitch - engages or disables WDTI signal function - (signal will pass un-
affected in bypass mode.)
Congratulations on your purchase of the new EDEN WTDI.
Performance and portability are the key features in this palm-
sized package of “World Tour” tone!
NEVER COMPROMISE.