ETS-Lindgren 2110 Multi-Axis Positioning Systems (MAPS) User Manual
Page 19
Installation
|
19
4.0 Installation
Before connecting any components, follow the safety
information in the ETS-Lindgren Product Information
Bulletin included with your shipment.
Proper installation of the MAPS directly affects
performance. The installation of the MAPS must be
performed by factory installation specialists or
individuals authorized by ETS-Lindgren to perform
installation. This information provided in this manual is
intended to be used only by those installation specialists.
See the assembly drawings located in the back pocket of
the manual to assist with installation.
If you have any questions concerning installation, contact ETS-Lindgren
Customer Service for Customer Service contact information.
The installation of the Multi-Axis Positioning System (MAPS™) will take
approximately eight hours and will require a minimum of two people.
Required Tools
The following tools are required to install the MAPS:
• Power hand drill, 3/8-in chuck
• Drill bit, 3/16-in diameter
• Drive bit, square (provided)
• Drive bit, #2 Phillips
• SAE hex key wrench set (maximum 1/2-in)
• Permanent
marker
• Laser level, 5-beam, and stand
• Bubble level (36-in minimum)
• 10-in adjustable, open-ended wrench
WARRANTY