Hollywood Racks HR2500 Commuter - Manual (Page 2)

2
Assembly step 2:
Attach receiver tube
1. Locate ½” bolt, washers and
locknut (B).
2. Place a washer on the end of the
bolt, and insert through the lower
hole of the receiver tube’s bracket
and lower beam as shown in fig. 6a.
3. Attach other washer to bolt end,
and install nut. Tighten nut onto bolt
end using both wrenches.
4. Insert “lynch pin” through upper
holes of bracket and tube, then
fasten clasp on the pin per fig. 6b.
Fig. 6a
Fig 6b