Koala Kare 740-KIT-INB - Manual

Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
®
Tools Supplied:
5/32” and 1/8” Allen Wrench
1. To enable you to remove the waist strap,
slightly loosen the screws on the sides of the seat,
but – DO NOT REMOVE.
2. To remove the strap, turn the chair onto its side
to reveal the underside of the seat. Unscrew the
two screws from the two narrow chafe tabs on
underside of the seat using the 1/8” Allen Wrench
supplied. Discard the old strap and screws.
3. Loosen the side panels from the seat slightly
using the 5/32” Allen Wrench supplied and pull
the straps out through the slots on each side of
the chair. Keep the wide middle strap in the slot.
4. To install the new strap, stand chair upright,
place the strap on the seat. Thread the chafe tabs
through the slots to the underside of the seat.
5. Once the straps are threaded through to the
underside of the seat, thread the 2 Hex Head
Machine Screws provided through the plastic
chafe tabs. Tighten each screw into seat.
6. Slot the seat back into the sides and tighten the
side bolts that were loosened in step 1. Ensure
straps do not move from their position.
DESIGNER HIGH CHAIR REPLACEMENT STRAP INSTRUCTIONS
Active Restraint Strap for the KB105-INB
P/N 740-KIT-INB
P/N 354 December 2010
Hardware Supplied Two 5/8” Hex Head Machine Screws