Kontron CP6002 uEFI BIOS - Manual (Page 30)

Chipset Setup CP6002 uEFI BIOS
Page 24 ID 1039-1612, Rev. 2.0
3.1.1.1.2 SATA Mode Selection
This function is used to select the operational mode of the SATA controller(s) when enabled.
Default setting: IDE
3.1.1.1.3 Serial ATA Ports 0 - 5
Displays an identifier string if a device is connected to the port indicated (0-5).
3.1.1.1.4 Software Preserve Ports 0 - 5
Indicates whether or not a connected device supports Software Setting Preservation (SSP).
3.1.1.1.5 SATA Speed Limit Ports 0 - 5
This function is used to limit the transfer speed of a SATA port. This function is available only
when the SATA mode is set to IDE.
Default setting: No Limit
SETTING DESCRIPTION
IDE Use this setting to select IDE mode operation.
AHCI Use this setting to select AHCI mode operation.
RAID Use this setting to select RAID mode operation.
SETTING DESCRIPTION
No Limit Use this setting for no transfer speed limit
Gen1 Use this setting to restrict port to Generation 1 communication rate (1.5 Gb/s).