Kontron ETX-LX - Manual (Page 42)

11 Appendix C: BIOS Operation
Kontron User's Guide ETX®-LX 42
Feature Option Description
Hi,Lo
Lo,Hi
Lo,Lo
IR Transmission Delay
Disabled
Enabled
Allows you to enable/disable a transmission delay
UR2 Duplex Mode
Full
Half
Allows you to select the transmission mode for your device
Use IR Pins
RxD2,TxD2
IR-Rx2Tx2
Onboard Parallel Port
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
This item allows you to determine which access onboard parallel port
controller goes with which I/O address.
Parallel Port Mode
Standard
EPP
ECP
ECP+EPP
Select an operating mode for the onboard parallel (printer) port. Select
EPP or SPP depending on which mode your hardware and software is
supporting.
Note: If ECP Mode is selected for onboard LPT, DMA is not possible
on ISA Bus devices.
EPP Mode Select
EPP1.7
EPP1.9
Select EPP port type 1.7 or 1.9
ECP Mode Use DMA
1
3
Select the DMA channel for ECP
External FDC Controller
Disabled
Enabled
Select "Enabled" if your system has the Super I/O-controller FDC37C669
installed on the system board and you wish to use it. If you have installed
an add-in FDC or the system has no floppy drive, select Disabled.
External Serial Port 3
Disabled
3F8
2F8
3E8
2E8
Select an address for the third serial port
External Serial 3 use
IRQ IRQ11
IRQ10
Select an interrupt for the third serial port
External Serial Port 4
Disabled
3F8
2F8
3E8
2E8
Select an address for the fourth serial port
External Serial 4 use
IRQ IRQ11
IRQ10
Select an interrupt for the fourth serial port
External Parallel Port
Disabled
3BC
378
278
FDD
Select an address for the external parallel port
External Parallel Use
IRQ IRQ7
IRQ5
Select an interrupt for the parallel port
External Parallel Mode
SPP
EPP
ECP
Select an operating mode for the external parallel (printer) port