La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 4)

F IGURE 2
F IGURE 4 F IGURE 3
Power
Transformer Box Power Transformer
Connector
F IGURE 1
Cable Tie
Fastening Tape Black Nonwoven Flap
F IGURE 6 F IGURE 5
Back and Body
Brackets Engaged Locking Lever in Locked Position
(1ML shown) (1ML shown)
Black Nonwoven Flap
Luxury-Lift ® Power Recliner
Assembly Instructions
Luxury-Lift ® Power Recliner
Assembly Instructions
NOTICE:
Do not plug the transformer in until instructed.
1. Carefully cut the cable tie holding the Power Transformer box to the rear rail (F IGURE 1).
Set the box aside.
2. The Power Transformer connector is tucked into the rear upholstered panel, toward the bottom
of the chair (F IGURE 1). Remove the Power Transformer connector from the upholstered panel.
3. Roll the lift chair onto its back side. Locate the cable tie on the rear base (F IGURE 2).
• Carefully cut the cable tie securing the lift base (F IGURE 2).
• Return the lift chair to the upright position, being careful not to pinch the Power
Transformer connector or cord.
4. Lay the back across the chair arms with the front of the back facing the seat.
• Note the location of the fastening tape on the black nonwoven flap and the fastening tape
on the back seat spring rail (F IGURE 3). Do not attach the fastening tape at this time.
• Lay the black nonwoven flap down toward the seat (F IGURE 4).
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
5. Install the back.
• With the back across the chair arms, lift the back at a slight angle and align the brackets
on the back with the brackets on the body.
• Lower the back onto the body, making sure the back and body brackets are completely
engaged (F
IGURE 5).
- Lift the back upholstery cover to visually confirm that both sets of back and body brackets
are engaged (F IGURE 5). If one or both brackets are not engaged, remove the back and repeat
the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy ® dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F IGURE 6).
(Assembly Instructions Continued)
7 6
(1ML shown) (1ML shown)