Mercedes-Benz S-Class 2011 - Manual (Page 380)

The selected unit of measurement for
distance applies to:
R
the analog speedometer
R the digital speedometer in the Trip menu
R the odometer and the trip odometer
R the trip computer
R
the navigation instruction in the Navi menu
R
DISTRONIC PLUS
R ASSYST PLUS service interval display
The digital speedometer shows alternative
speed units (
Y page 377).
X Press the = or ; button on the
steering wheel to select the
Settings
menu.
X Press 9 or : to select Units .
X Press the a button to confirm.
X Press the a button to save the setting.
The unit switches
km/h and mph .
Switching the belt adjustment on/off
Further information on belt adjustment:
(
Y page 58).
X Press = or ; on the steering wheel
to select the
Settings menu.
X Press the 9 or : button to select
Belt Adjustment .
X Press the a button to confirm.
X To activate/deactivate: press a
again.
Activating/deactivating the acoustic
locking confirmation
If you activate the Acoustic Lock Feedb.
function, an audible signal sounds when the
vehicle is locked or unlocked. When
unlocking, the signal sounds once. When
locking, it sounds three times.
X Press the = or ; button on the
steering wheel to select the
Settings
menu.
X Press 9 or : to select Acoustic
Lock Feedb. .
X Press the a button to confirm.
X To activate/deactivate: press a
again.
Activating/deactivating the radar
sensor system
The following systems are switched off when
the radar sensor system is deactivated:
R
DISTRONIC PLUS ( Y page 325)
R
BAS PLUS ( Y page 68)
R PRE-SAFE ® Brake ( Y page 71)
R
Blind Spot Assist ( Y page 352)
R
Active Blind Spot Assist ( Y page 356)
i USA only: This device has been approved
by the FCC as a “Vehicular Radar System”.
The radar sensor is intended for use in an
automotive radar system only. Removal,
tampering, or altering of the device will void
any warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
i Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause interference,
and
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
378
Menus and submenus
On-board computer and displays