Mercedes-Benz G-Class 2006 Owners Manual - Manual (Page 216)

215
Controls in detail
Useful features
Operation of integrated remote control
̈ Switch on the ignition ( ୴ page 35).
̈ Select and press the appropriate inte-
grated signal transmitter button (
2,
3, or 4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition ( ୴ page 35).
̈ Simultaneously hold down the signal
transmitter buttons
2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp
1 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated sig-
nal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Press and hold the desired signal trans-
mitter button (
2, 3, or 4). Do not re-
lease the button.
̈ The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
Heated steering wheel
The steering wheel heater warms up the
leather area of the steering wheel.
The lever with the heated steering wheel
switch is on the lower left-hand side of the
steering wheel.
1 Switching on
2 Switching off
3 Indicator lamp
i
If you sell your vehicle, erase the codes
of all three channels.