Oldcastle BuildingEnvelope Solar Shelf - Manual (Page 9)

8 


S U N C O N T R O L - I N S T A L L A T I O N M A N U A L
SOLAR ECLIPSE
Reliance Sealant
™
Seal gap between cover plate
and pressure plates.
Seal gap between anchor
and cover plate
FIGURE 8
Install WW-162-02 cover plate
after glass is installed.
attach with (2) FS-325 fasteners
1/8"gap
Note:
1) Typical pressure plates will be installed above
and below cover plate.
2) See FIGURE 6 page 7 for face cap fabrication.
1.3 Sealant
6) Clean all surfaces to be sealed using isopropyl alcohol. Then seal cover plate to anchor to
prevent any water infiltration. See FIGURE 8.
7) Pressure plates should be located above and below the cover plate allowing 1/8" joint. This
joint should be cleaned and sealed. See FIGURE 8.