Zippy ARD-6400F - Manual (Page 30)

INPUT CHARACTERISTICS: ARD / I – 2/4/6300F
VOLTAGE: 90 – 132 VAC / 180 ~ 264 VAC SWITCHABLE
FREQUENCY : 47 ~ 63 Hz
INPUT CURRENT: 5.0 / 2.5A FOR 115 / 230 VAC PER POWER MODULE
( PARALLEL )
INRUSH CURRENT: 50A / 100A MAX. FOR 115 / 230 VAC
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
MIN.[A] MAX.[A] PEAK(A) LOAD LINE
5V** 7.0 20~36 40 ± 5% ± 1% 60mV
12V** 2.5 17 20 ± 8% ± 1% 120mV
-5V*** 0 0.8 1 ± 10% ± 1% 120mV
-12V*** 0 0.8 1 -10%~+10% ± 1% 150mV
3.3V* 3.0 0~25 30 ± 5% ± 1% 60mV
+5VSB 0 1.0 1.2 ± 5% ± 1% 50mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. [P-P]
* MANUFACTURER SET AT 3.45 V
*TOTAL OUTPUT OF +5V AND + 3.3V NOT EXCEED 180 W
** For ARD/ I / H – 2300F ; **&*** For ARD/ I / H – 4300F
Total output max:300W
TEMPERATURE RANGE: OPERATING 0 --- 40
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
EFFICIENCY: 65% TYPICAL, AT FULL LOAD
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
OVER LOAD PROTECTION: 130 +/- 20%
OVER VOLTAGE PROTECTION:
+5V
6.0V ~ 7V, 3.3V 4.0 ~ 4.5V, ( EACH POWER MODULE )
OVER CURRENT PROTECTION : SHORT CIRCUIT
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B
SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE / ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
HOT-SWAPPABLE / HOT-PLUGGABLE REDUNDANCY FUNCTION
BALANCE LOAD SHARING DESIGN
REMOTE SENSING DESIGN
ISOLATION: BUILT-IN IN THE POWER MODULE
PASSIVE BACKPLANE DESIGN
DIMENSION: ARD: 153(W) x 212(H) x 190(D); ARI: 167(W) x 189(H) x 190 (D);
CONNECTION: 48 PINS CONNECTOR (EPT PART NO. 109-40064 OR EQUIVALENT)
6 PINS CONNECTOR (POSITRONIC PART NO. PLB06M8000 OR
EQUIVALENT) OPTIONAL FOR INPUT SOURCE FROM REAR SIDE
I
2
C COMMUNICATION ABILITY (OPTIONAL)
Revision: A01