Bissell 11323 - Manual (Page 6)

Getting Ready___________
The mop pad may have already come attached
to the mop pad tray on the foot of the unit. If
not, please follow step 1 below
1. Attach mop pad.
a. Step on foot release for mop pad tray
to lift unit off tray.
b. Add Freshening Disc in the mesh pocket
in the mop pad. Use the whole disc for
refreshing scent or cut in half for a lighter
scent.
c. Wrap mop pad around the bottom of
the tray, making sure the gray stitching is
in the front and the quick release tab is in
the back.
d. Put the mop pad tray back down on
the floor and set the unit back on top. It
will click into place.
2. Fill the water tank.
a. On the back of the unit, open the Easy
Fill opening of the water tank and use the
included water cup to fill the water tank with
water. Don’t overfill or water may spill from
the tank. For best results, water should be at
room temperature.
b. Close the Easy Fill opening.
c. The water tank holds 13oz. and will last
approximately 15 minutes depending on the
amount of the steam used during cleaning.
3. Twist the Quick Release™ cord wrap clockwise
to unwrap the power cord completely and plug
into an outlet as described on the Important
Safety Instructions on page 2.
4. Adjust the handle for your most comfortable
cleaning height by pressing the tab at the base
of the handle with one hand and pulling the
handle up with your other hand.
NOTE: Upon the first use of the hard floor
cleaner or first use after refilling the water tank,
the pump may make a ‘knocking’ sound. This Is
normal and could last up to 30 seconds.
AWARNING
Do not operate appliance with damp or wet
filters or without all filters in place.
AWARNING
Tinted plates on foot may get hot while steam
mop is in use. Do not touch while hot.
2 .
'Up
»Use of distilled water is
recommended to prolong
the life of your hard floor
cleaner.
6
www.BISSELL.com