Docking the computer, Docking the computer -4, Ocking the computer – Dell C/Dock Expansion Station User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• An infrared device that works with the infrared
port on the C/Dock Expansion Station (see
Figure 1-2) and the data communications soft
ware on the computer’s hard-disk drive.
For more information, see “Using External Devices”
in the online System User s Guide.
2. Connect the external devices to their power
sonrces.
3. Connect the C/Dock Expansion Station to alter
nating cnrrent (AC) power.
Connect the AC power cable to the AC adapter. Next,
plug the AC adapter cable into the AC adapter con
nector on the computer. Then, plug the AC power
cable into an AC power source.
An AC adapter must be attached to the C/Dock
Expansion Station before you connect it to the
computer and turn on the computer. The AC adapter
powers the C/Dock Expansion Station and the
computer at the same time. Any battery installed in
the computer charges while you use the C/Dock
Expansion Station.
CAUTION: Always nse the Dell AC adapter
that came with the C/Dock Expansion Station.
(Look for model nnmber PA-2 or PA-6 on the
bottom of the AC adapter.) Using any other
commercially available AC adapter—or the
AC adapter from older models of Dell compnt-
ers—conld damage the C/Dock Expansion
Station or the compnter.
If the AC adapter cable is accidentally unplugged
from the C/Dock Expansion Station, your data is
safe as long as you have a charged battery in the
computer.
Place the C/Dock Expansion Station and docking
control base in a convenient location on yonr desk
or work area.
Attach the monitor stand to the docking control
base (see Fignre 1-3), and then set an external
monitor on top of the stand.
The stand supports monitors that weigh up to
45.3 kilograms (kg) (100 pounds [lb]).
D
ocking the Computer
Use the following instructions to dock the computer to
the C/Dock Expansion Station.
NOTE: If you are using Windows NT and the C/Dock
Expansion Station has a PCI expansion card installed,
before docking the computer you must save all files, close
and exit all application programs, exit the operating sys
tem, and turn off the computer.
1. Open the docking panel door on the back of the
compnter (see Fignre 1-4).
Figure 1-4. Docking Panei Door on the
Computer
1-4 Dell Latitude C/Dock Expansion Station User’s Guide