Outdoor Great Room GBI-41 Built In Electric Fireplace - Manual (Page 6)

5
PREPARATION
1. TOOL REQUIRED
Magnetic Phillips Screw Driver
2. UNPACK THE FIREPLACE HEATER
WARNING! Do NOT use this Electric Fireplace if any part has been under water. Immediately call a
qualified service technician to inspect and to replace any part of the electrical system if necessary.
Keep plastic wrapping away from children.
WARNING! Remove all parts and hardware from the carton and place them on a clean, soft, dry
surface. Parts and assembly steps are grouped. Check the parts list to make sure nothing is missing.
Dispose of packaging materials properly. Please recycle whenever possible.
PARTS AND HARDWARE
INCLUDED PARTS
Remote Control (1pc)
AAA battery (2pcs)
Screw ST4×16 (2pcs)
Screw ST4×8 (6pcs)
Fixing bracket (2pcs)
Airflow plate (1pc)
Fireplace insert (1pc)
Front Face (1pc)
INSTALLATION
1. LOCATING YOUR ELECTRIC FIREPLACE
Note!
Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a
location ensure that the general instructions are followed. For best results, install out of direct sunlight. Power
supply service must be either completed or placed within the electric fireplace prior to finishing to avoid
reconstruction.
Note! A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of
the fireplace. Plan the installation to avoid the use of an extension cord. Preferably, the fireplace will be on a
dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow
when the heater is in operation.
2. CLEARANCE TO COMBUSTIBLES
Sides …………………………0 in. (0 mm)
Floor
………………………….0 in. (0 mm)
Top ……………………………0 in. (0 mm)
Bac
k …………………………..0 in. (0 mm)