Outdoor Great Room CNG-Traveler Gas Grill - Manual (Page 8)

The Outdoor GreatRoom Company • Cook Number Grill CNG-TRAVELER Gas Grill • Rev. A
8
Step 3. Check Grease Drawer
1. Parts/Items Needed: None
2. Pull the grease drawer out of the grill at the left front
corner. Check that the aluminum tray is secured in the
brackets underneath the drawer and slide the drawer
back into the grill. (See Figure 4).
Figure 4
Figure 5
CAUTION
Before the first use and at the beginning of each sea-
son (and whenever the LPG gas cylinder has been
changed):
1. Read all safety, lighting and operating instructions.
2. Check gas valve orifices, burner tubes and burner
ports for any obstructions.
3. Perform gas leak check according to instructions
found in this manual.
CAUTION
When the appliance is not in use, the supply cylin-
der must be detached from the appliance.
B. Disconnecting a 1 lb. Disposable Liquid Propane
Gas (LPG) Cylinder from the Grill
1. Turn burner control knob to the full OFF position. (Turn
clockwise to close.)
2. Detach the LPG cylinder by turning the Quick Coupling
Nut of the connection tube counterclockwise.
Step 4 Connecting Gas Cylinder
A. Connecting a 1 lb. Disposable Liquid Propane Gas
(LPG) Cylinder to the Grill
1. Make sure the burner control knob and OFF/ON rocker
switch are in the OFF position.
2. Check the cylinder valve features to ensure it has prop-
er external mating threads to fit the grills LPG regula-
tor. Screw the LPG regulator to the cylinder and hand
tighten.
3. Inspect the grill’s gas manifold connection port for any
damage or debris. Remove any debris. Never attempt
to use damaged or plugged equipment.
4. When connecting the LPG cylinder to the manifold
connection, hand tighten the nut of the connection tube
clockwise to a full stop (see Figure 5). DO NOT use a
wrench to tighten because it could damage the Quick
Coupling Nut and result in a hazardous condition.
5. Checking For LP Gas Leaks
Never test for leaks with a flame. Check for gas leaks prior
to first use, at the beginning of each season, or every time
the LPG cylinder is changed. Follow these four steps:
Use a commercially-available non-corrosive leak check •
solution.
Turn the grill ignitor control knob to the full OFF position
•
(clockwise).
Apply the leak check solution to all gas connections.
•
Bubbles will appear in the leak check solution if the con-
nections are not properly sealed. Tighten or repair as
necessary.
If there is a gas leak that cannot be repaired, disconnect
•
the cylinder from the grill and call the gas grill dealer, or gas
supplier for repair assistance.
NUT
LPG
Cylinder
Grease Drawer
Aluminum Tray