Outdoor Great Room Gas Grill LG36i - Manual (Page 11)

The Outdoor Greatroom Company • Legacy Gas Grill • Rev. E
11
Step 2. Assemble Casters
1. Parts/Items Needed: Two front swivel castors with
brakes, two rear swivel castors, and the 3/4 inch open
end wrench (from parts Carton A). See Figure 7.
Carton D
1 - Stainless Steel Warming Grid
2 - Warming Grid Legs
1 - Searing Plate
Figure 5
Stainless Steel
Warming Grid
Carton E
2 - Side Tables
2 - Condiment Trays
16 - Philips Head Screws
6 - Grilling Tool Hooks
2 - Handles
Figure 6 (One side table and one condiment tray shown).
Figure 7
Important: Work on a non-abrasive carpet, blanket or
cardboard (outer cardboard shipping sleeve can be used)
or grass while installing the casters.
2. Two people should assist one another during this
procedure.
Carefully tip the grill/cabinet assembly and lay it flat
on it’s back. Screw the four castors into the threaded
holes at the corners of the cabinet base. The two cas-
tors without brakes go to the rear and the two castors
with brakes go to the front. Tighten each castor with the
3/4 inch open end wrench.
Step 3. Gas Manifold
1. Parts/Items Needed: 3/4 inch open-end wrench. See
Figure 8.
Figure 8
2. The gas manifold is factory installed as part of the con-
trol panel assembly attached to the front of the grill
cabinet.
Warming
Grid Legs
Searing Plate
Condiment Tray
Screws
Side Table
Front Casters
Rear Casters
Wrench
Flex tube from supply cylinder
bulkhead to top of gas manifold
Flex tube from
orifice to bottom of
gas manifold
Tool Hooks
Handles