Ryobi CSB1308 - Manual

RYOBI TECHNOLOGIES INC.
CSB CIRCULAR SAW REPAIR SHEET
For Models CSB120, CSB130, CSB130JS and CSB1308
Fig. 3
Fig. 1
Fig. 2
UPPER BLADE GUARD
MOUNTING SCREW UPPER
BLADE GUARD
UPPER BLADE
GUARD
MOUNTING SCREW
UPPER BLADE GUARD
MOUNTING SCREW
LOWER BLADE GUARD
STOP BRACKET
This kit contains the necessary parts and instruction sheet
for the repair of all Ryobi brand circular saws with the model
number of CSB120, CSB130, CSB130JS, and CSB1308.
REPAIR KIT CONTENTS:
■ Lower blade guard stop bracket (1 ea.) – See Figure 2.
■ Lower blade guard handle (1 ea.) – See Figure 4.
■ Instruction Sheet (1 ea.) – Not Shown
TO REMOVE BLADE
■ Unplug your circular saw.
WARNING:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
■ Refer to your saw’s operator’s manual.
■ Depress the spindle lock to secure the blade, or place
the blade on a piece of scrap wood to hold the blade
stationary.
■ Using the 9/16 in. blade wrench supplied with your saw,
turn the blade bolt counterclockwise to loosen.
■ Remove the blade bolt, spring washer, outer blade washer,
and blade.
TO INSTALL LOWER BLADE GUARD STOP
BRACKET
■ Using a #2 Phillips screwdriver, remove the right upper
blade guard mounting screw.
See Figure 1.
■ Align hole in lower blade guard stop bracket with mounting
hole where the screw has been removed.
Note: On some saws, the holes may not align perfectly.
However, the holes will align during tightening.
■ To prevent screw strippage or thread damage, apply light
hand pressure and turn upper blade guard mounting screw
counterclockwise one full turn or until screw threads seat.
Then turn screw clockwise to tighten.
See Figure 3.
■ Tighten screw securely.
WARNING:
Failure to tighten the upper blade guard mounting screw
securely could result in serious personal injury.
LOWER BLADE
GUARD
STOP BRACKET
IF YOU EXPERIENCE ANY PROBLEMS OR
NEED FURTHER ASSISTANCE WITH MAKING
THE REPAIRS IN THIS KIT, CALL
1-800-867-9624.
ALTERNATE VIEW