Zigen HX-88 - Manual (Page 9)

Matrix Switching System—User Manual
9
 Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source.
 Power Switch: To switch power ON or OFF
 RS-232: Use the RS-232 connection cabel to connect the computer serial port (COM1
or COM2) to the RS232 communication port of the HDMI matrix host. The computer
can then be used to control the HDMI matrix after installation of application software.
The RS-232 port is a 9-pin female connector.
 IR2: Connect to the IR Extended Receiver
.
 Switcher:
- Pin1: Switch between RS-232 port and LAN port connection.
- Pin2: This Pin allows you to reset the IP value to 192.168.0.3. The steps are as
below:
a. Please switch the pin2 down and re-start HX-88.
b. After the HX-88 re-starts about 10sec, shut down your equipment.
c. Switch the pin2 up, then power on HX-88 again.
d. The IP address will be restored to the default value: 192.168.0.3
- Pin3: No definition.
Pin # UP DOWN
1 LAN RS-232
2 NORMAL IP DEFAULT
3 NC NC
 LAN Port: Use the RJ-45 connection cable to connect the Internet and the HDMI
matrix host. All PC ’s in the same network can control the HDMI matrix host through the
LAN port.
 IN1~8: HDMI input ports are connected to DVDs.
 OUT1~8: HDMI output ports are connected to HDTVs.
Daughter board modules:
MX-HDI1 HDMI Connector input
MX-HDO1 HDMI Connector output