Assembly of pivot ball type (m style) suspension, Assembly of the front suspension arms, m style, Assembly of the front shock tower – OFNA Racing Worlds II User Manual
Page 9
ASSEMBLY OF PIVOT BALL TYPE (M STYLE) SUSPENSION
Assembly of the right and left hand side
are the same.
Step 1
#36901
Ball Type
Knuckle Arm
( Right and Left )
R
* Use 5mm
hex wrench.
#36903
13.8mm
Steering Ball
#36905
Steering Ball
Washer
#36904
14mm
Alum. Nut
R
#36053
8x16mm
Ball Bearing
#36053
8x16mm
Ball Bearing
#36052
CVA,
Constant Velocity Axle, 8mm
* Adjusr alum. Nut to
keep steering ball
smoot.
* Note the "R" mark
are for rightside.
#36903
13.8mm Steering Ball x 4
#36904
14mm Alum. Nut x 4
#36905
Plastic Washer & Arm Adjusters
#36901
Ball Type Knuckle Arm
( Right )
( Left )
#36900
Front Upper Arm
#36890
Front Lower Arm
#36902
Rear Lower Arm
ASSEMBLY OF THE FRONT
SUSPENSION ARMS, M STYLE
#30010
Main Gear Box
#30010
Main Gear Box
4 x 20mm
Flat Head
Tapping Screw
#36620
Front Shock Tower
#30340
Anti-roll Bar Kit
* Insert front stabilizer before
assembly shock tower.
4 x 10mm
Tapping Screw
#36670
Alum. Blue Front
Upper Arm Holder
3 x 20mm Flat Head
Tapping Screw
4 x 10mm
Tapping Screw
ASSEMBLY OF THE FRONT SHOCK TOWER
* Make two gear boxes for front and
rear.
GEAR
GREASE