Daiwa TANACOM BULL 750 - Manual (Page 16)

14
Main line
Backing line
Tie
3
Line data input
(With backing line---P2)
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 100 m.
1
5. When P1 is blinking, press the MODE BUTTON to display the
screen for P2 backing line input.
It turns to P2 mode and P2 blinks.
4
5
1.
Pass the backing line through the hole of the Levelwind to be
tied onto the pin found on the spool, and then turn the power
on.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
2.
Wind the backing line.
If the power lever is not already at OFF position, then pull it
back to OFF position before beginning to wind.
3. When the backing line is wound up, tie both ends of the lines
securely.
(Prepare to wind up the main line.)
4.
Press the MODE BUTTON for 5 seconds, when the display will
show 0.0 .
It turns to P1 mode and P1 blinks.
Levelwind Guide
Main line
Pin
Power lever
OFF
2